CADDX xGenConnect, Installation And Programming Manual

Page: 134 / 166

122 xGenConnect Installation and Programming Guide
was included in the Channel Group, then the control room will receive duplicate
messages.
Next
Program your Partitions and Zones.
Programming Instructions for Zone Reporting
Goal
Direct event messages (e.g. alarm, bypass, tamper) from zones to specific
destinations.
Pre-conditions
• The zone must have valid zone options programmed (see “Programming
Instructions for Zones
” on page 92), by default you should not need to modify
these.
• The zone must be allocated a valid Partition Group (see “Programming
Instructions for Zones
” on page 92).
• Channels and Channel Groups must be programmed (see “Programming
Instructions for Channels
” on page 118).
Notes
• Each zone may be allocated to multiple Partitions through a Partition Group.
• Events will be sent to the lowest numbered Partition in the Partition Group.
• A zone may have a Second Zone Profile, when this becomes active all events
will be sent to the Partition Group programmed in the second profile.