Buell XB 2010, Service Manual

Page: 213 / 714

2.34
FOOTPEG, HEEL GUARD AND MOUNT:
FIREBOLT AND LIGHTNING MODELS
RIDER
REMOVAL
1. See Figure 2-178 . Remove wear peg (7) from end of
footpeg assembly.
2. Remove clip (5).
3. Remove footpeg pin (9).
4. Remove footpeg (8).
5. Remove heel guard fasteners (4).
6. Remove heel guard (3).
7. Remove footpeg mount fasteners (2).
8. Remove footpeg mount (1).
9. Position footpeg mount (1).
10. Install footpeg mount with fasteners (2). Tighten to 132-
144 in-lbs (14.9-16.2 Nm).
INSTALLATION
1. See Figure 2-178 . Position heel guard (3) onto footpeg
mount (1).
NOTE
There is one long fastener which installs on the lower left side
in order to secure the non-California vent clamp.
2. Install heel guard (3) with fasteners (4). Tighten to 72-96
in-lbs (8-10.8 Nm).
3. Position spring (6) in footpeg (8).
4. Position footpeg (8) and spring in footpeg mount (1).
5. Install footpeg pin (9).
6. Install clip (5).
7. Apply LOCTITE 271 (red) and tighten to 36-48 in-lbs (4-
5 Nm).
3
2
7
5
8
9
1
6
4
sm03637
1. Footpeg mount
2. Footpeg mount fasteners
3. Heel guard
4. Heel guard fasteners
5. Clip, footpeg
6. Spring
7. Wear peg
8. Footpeg
9. Pin
Figure 2-178. Rider Footpeg, Mount and Heel Guard:
Firebolt/Lightning
PASSENGER
REMOVAL
1. See Figure 2-179 . Remove clip (7).
2. Remove footpeg pin (9).
3. Remove footpeg (8), detent plate (6), ball (5) and spring
(4).
4. Remove heel guard fasteners (1).
5. Remove heel guard (2).
6. Remove footpeg mount fasteners (10).
7. Remove footpeg mount (3).
HOME
2010 XB Service: Chassis 2-133