Buell XB 2010, Service Manual

Page: 105 / 714

1
3
2
sm00515
1. Bridge
2. Nut
3. Forcing screw
Figure 2-8. Remove the Bearing
3
1
2
6
4
5
sm00516
1. Nut
2. Bridge
3. Forcing screw
4. Collet
5. Ball bearing
6. Wheel bearing
Figure 2-9. Removing Bearing from Puller
2. See Figure 2-10 . Remove the spacer.
3. Repeat previous steps for the bearing on the other side
of the wheel.
sm00517
Figure 2-10. Remove the Spacer
Front Rotor Removal
1. See Figure 2-16 . Remove and discard rotor mounting
fasteners (7).
2. Remove and inspect brake rotor (6) for wear and warping.
See
2.10 FRONT BRAKE: SIX PISTON CALIPER, Brake
Caliper: Cleaning and Inspection .
3. Remove drive bushings (8) and discard.
4. Remove washers (9) and discard.
5. Remove front brake springs (4) and discard.
CLEANING AND INSPECTION
Using compressed air to "spin dry" bearings can cause
bearing to fly apart, which could result in death or serious
injury. (00505b)
1. Inspect all parts for damage or excessive wear.
NOTE
The wheel bearings are designed as sealed bearings which
are not intended to be disassembled, serviced or cleaned with
solvents.
Always replace brake pads in complete sets for correct
and safe brake operation. Improper brake operation could
result in death or serious injury. (00111a)
2. Inspect brake rotor and pads. See 1.14 BRAKE SYSTEM
MAINTENANCE .
HOME
2010 XB Service: Chassis 2-25