Brother PD-3000, Instruction Manual

Page: 76 / 210

CHAPTER 3 PROGRAMMING WITH ICONS
68 PD-3000
Creating a multiple stitch
1. Select , and then press .
2. Input the stitch length and the number of lines
for a multiple stitch, and then press .
Move the needle to the next point with .
Press .
When changing the embroidering direction, provide
a split by pressing
twice.
Press and move the needle point from the
inside line to the outside line (or vice versa).
becomes valid after input of a split.
When programming, be sure that the points and
splits specified on the inside line are paired with
those on the outside line respectively.
3. Repeat step 3 until the needle reaches the end
point and press three times.
Calculation starts based on the input data. On
completion of the calculation, programming is
complete.
Creating needle drop data
Create needle drop data for the current needle position.
1. Select and press .
2. Move the needle to a point of which data you
want to set as needle drop data with
. Press .
Creating feed data
Create (feed) data to move the needle to the next position without needle drop at the current position.
1. Select , and then press .
2. Move the needle to a point you want use as feed
data with . Press .
Start point
Press twice.
Press twice.
Press .
Press twice.
Press
twice.
Press twice.
End point
Press
three times.