Brother PD-3000, Instruction Manual

Page: 105 / 210

CHAPTER 4 PROGRAMMING WITH COMMANDS
PD-3000 97
Pattern with curves
The following describes how to program a pattern with curves.
Be sure to press to make a split at a corner point C or E. If a split is not made, the corner will be
rounded.
When a split is made When a split is not made
Making more intermediate points such as points B, D, F, G, and H create smooth curves.
1. Carry out steps 1 and 2 of "Procedure for
programming with command".
2. Input the stitch length, and then press .
3.0 mm is input in the example.
Input "030" to make the stitch length 3.0 mm.
3. Move the work clamp with .
Press when the needle point is at B.
4. Move the work clamp with .
Press when the needle point
is at point C of the pattern.
Point C becomes a sharp corner. The points A to C
are programmed.
5. Press .
To change the stitch length, specify the pitch value
before pressing
.
6. Move the work clamp with .
Press when the needle point is at D of the
pattern.
7. Repeat step 6 and create the program to point E.
8. Press as in step 4.
The points C to E are programmed.
9. Create the program to point I in the similar
manner.
10. When point I is programmed, press
again.
11. Carry out steps 4 to 6 of "Procedure for
programming with command".