Brother PD-3000, Instruction Manual

Page: 127 / 210

CHAPTER 4 PROGRAMMING WITH COMMANDS
PD-3000 119
Moving a part of continuous program in parallel
The following describes how to move patterns B and C in parallel.
1. Carry out step 1 of "Procedure for modifying
program" to call program.
2. Press , and then press .
The work clamp moves from the start point by each
stitch.
3. When the needle point reaches 1, press .
The work clamp stops. When returning the needle
point, input the number of stitches to be returned and
press
.
4. Press , and then press .
Input the command for parallel movement.
5. Move the work clamp with .
Press when the needle point is at 2 of the
pattern sheet.
If pattern C is present after pattern B, pattern C is
automatically moved in parallel. If it is
inconvenient, move pattern C in parallel as in steps 1,
2, 3 and 4.
Or follow the chapter 3 "Moving a part of
continuous program in parallel partially" (page 60).
6. Carry out steps 3 and 4 of "Procedure for
modifying program" to save program.
Not trimming thread at the last stitch
Deleting the thread trimming code after inputting the end code can cancel thread trimming at the last stitch.
* For not trimming thread at the last stitch, you can also set the end code at "115". In this case, every thread trimming including the
emergency stop is canceled. Make the following setting for canceling thread trimming at the specified point.
1. Creating program
2. Input the end code.
The work clamp returns to the first stitch.
3. Press , and then press .
The work clamp moves to the last stitch.
4. Press .
5. Press .
6. Press .
The thread trimming code is deleted.
Pattern A Pattern B Pattern C
Feed