Brother PD-3000, Instruction Manual

Page: 168 / 210

CHAPTER 5 EXTENDED OPTION OUTPUT
160 PD-3000
5. Carry out sewing operation. Confirm that the left work clamp rises after the needle returns to the
sewing start point and it lowers when sewing begins.
As shown in the above example, when Timer 2 is set to [00], the on or off state will remain unchanged after the
condition is established.
„ Using trigger data to turn the output on while sewing
In the "Individually programming on and off" example, No. 15 was programmed to be turned on at the sewing start
point. However, in this example, change the setting so that No. 15 is turned on while sewing. Do not change the off
condition setting, "OFF when sewing starts", which was set for "Individually programming output on and off".
1. Read the written data by using .
2. Referring to the table of sewing machine operation mode condition numbers (see page 150), set "ON
when condition No. 14 (trigger data detection) is established". On the setting screen, overwrite the
values as follows.
Move the cursor to [ON]. Press the - key. The value is switched to OFF. Confirm that the data set in the
previous section remains.
3. Write the option program over the program on the CF card. Press to turn the programmer light
off.
4. Press the P key of the programmer again to read and edit the sewing data. Input trigger data at any
position. (See page 76.) On the trigger data screen, set option output No. 15 and sewing machine
pausepage OFF. On the setting screen, make the following settings.
5. Store the sewing data as a new program number after inputting the trigger data. Press to turn the
programmer light off. Turn off the power then turn it back on again.
Carry out sewing operation. Confirm that the left work clamp rises at the position where you input the trigger data
and that it lowers when sewing begins.