Brother PD-3000, Instruction Manual

Page: 138 / 210

CHAPTER 4 PROGRAMMING WITH COMMANDS
130 PD-3000
Creating an offset
Commands to be used
Creating an offset. Input the width of offset stitch in
Values 1.0 to 9.9 mm are available for the width
Example: Width Input value
1.5 mm 415
Input the stitch length in .
Carrying out offset on the left of the sewing path
Carrying out offset on the right of the sewing path
Starting offset calculations
(This is the code to end programming. For details, refer to page 133.
）
1. Select the sewing start point with ,
and then press .
2. Input the stitch width, and then press
.
3. Move the needle point to the second point or
after with . Press .
4. When the needle point is moved to the corner,
press .
5. Repeat steps 3 and 4 and move the needle to the
end point. Then input .
When the calculation is complete, the needle point
moves to the end position.
Creating feed data
Commands to be used
Specifying split (the separation point for different patterns in sewing) after feed
Moving in parallel for the feed
Creating split data after basting
Creating basting data
* To cancel basting, input at the basting position.
1. Press .
2. Determine the feed point with .
3. Input command depending on the feed.
If not specified, press .