Brother PD-3000, Instruction Manual

Page: 50 / 210

CHAPTER 3 PROGRAMMING WITH ICONS
42 PD-3000
■
Programming
1. Carry out steps 1 to 3 of "Procedure for
programming with icons".
2. Select with , and then press
.
3. Select with , and then press
.
4. Input the stitch length and the number of lines
for a multiple stitch. Press .
Input "020" to make the stitch length 2.0 mm.
Switch between the input fields of stitch length and
the number of lines for a multiple stitch with
.
5. Move the work clamp with .
Press when the needle point is at point 2
of the pattern sheet.
6. Move the work clamp with .
Press twice when the needle point is at
point 3 of the pattern sheet.
Be sure to press twice for a split at a corner at
a sharp angle like point 3. If a split is not made, the
corner will be round.
7. Program the following points up to point 17
with the curve programming steps.
⇒
Refer to "Pattern with curves" (page 34).
When programming a line, move the needle point
from the line start point to the line end point, and
press
twice.
In the example, a linear line is programmed between
points 7 and 9. Be sure to program a linear line
also for the matched section between points 24 and
26.
To return the needle point, follow the steps below.
Returning to the previous point: Press
(The needle cannot be returned beyond the previous
split.)
Returning the previous split: Press (When
the needle position is at a split, it cannot be moved.)
Returning to the split before the previous one: Press
.
8. Press and move the work clamp with
. Press when the needle
point is at point 18 of the pattern.
9. Program the following points up to point 34 in
the same manner.
When programming, be sure that the points and
splits specified on the inside line are paired with
those on the outside line respectively.
If the points inside and outside are not paired, the
needle point is automatically returned to the previous
point. In such cases, perform programming again.
10. Press .
11. Press .
12. Carry out steps 5 to 7 of "Procedure for
programming with icons".
19
18
1
2
3
4
5
6
7
8
9
10
12
13
14
15
16
17
34
33
32
31
30
28
27
26
25
24
23
22
21 20
11
29
(A)