Brother PD-3000, Instruction Manual

Page: 42 / 210

CHAPTER 3 PROGRAMMING WITH ICONS
34 PD-3000
Pattern with curves
The following describes how to program a pattern with curves.
Be sure to press twice to make a split at corner points C or E. If a split is not made, the corner will be rounded.
When a split is made When a split is not made
Making more intermediate points such as points B, D, F, G, and H creates smoother curves.
1. Carry out steps 1 to 3 of "Procedure for
programming with icons".
2. Select with , and then press
.
3. Select with , and then press
.
4. Input the stitch length, and then press .
Input "030" to make the stitch length 3.0 mm.
5. Move the work clamp with .
Press when the needle point is at point B.
6. Program point C as in step 5.
7. When point C is programmed, press again
for a split.
To change the stitch length, press to reset.
8. Create the program to point E.
9. When point E is programmed, press .
10. Create the program to point I.
11. When point I is programmed, press .
12. Press three times.
13. Carry out steps 5 to 7 of "Procedure for
programming with icons".