Brother PD-3000, Instruction Manual

Page: 166 / 210

CHAPTER 5 EXTENDED OPTION OUTPUT
158 PD-3000
5. Select , and then press .
6. Select , and then press .
7. Press to turn the programmer light off. Turn off the power then turn it back on again.
Initial settings are carried out at power-on; after writing extended option outputs, turn off the power once. (In this
case, carry out initial settings so that output No. 15 does not function as the left work clamp, but functions as the
extended option.)
8. Read short sewing data of approximately 10 stitches. Set the memory switch No. 50 to 4 (the work
clamp is not are automatically raised when sewing is completed). Carry out sewing operation.
Confirm that the left work clamp is in the raised position, that it stays in that position for one second, and then
lowers whenever the needle returns to the sewing start point. If the left work clamp operates in this manner, it is
operating in accordance with the program.
„ Modifying programmed data
Modify existing program data according to the procedure described in "Turning the output interlocking on and off
corresponding to sewing machine operations".
In most cases, only one option program can be stored on one CF card. (It has file name is
［
ISMSEQ00.SEQ
］
.)
1. Confirm that the CF card written to in accordance with the procedure described in "Turning the output
interlocking on and off corresponding to sewing machine operations" is loaded. Display the extended
option output home screen (shown below).
2. Read the written data by using .
3. Display the output setting screen. Set Timer 1 to 0.5 sec. (500 ms) and Timer 2 to 0.5 sec. (500 ms).
On the setting screen, make the following settings.
Move the cursor to the set value [1000] at Timer 2. Write [0500] over it.