Brocade Communications Systems VDX 6940 Series, Hardware Installation Manual, Page: 61 / 136

FIGURE 37 Attaching the rear brackets to a rack
1. Retainer nuts, 10-32
2. Rear brackets (in right and left sides)
3. Screws, 10-32 x 5/8-in., panhead Phillips
Attaching rear brackets to the switch
Complete the following steps to attach the rear brackets to the switch.
1. Align the right rear bracket to the right rear of the switch and use four 8-32 x 5/16-in. panhead screws
to attach the bracket to the switch as shown in Figure 38 . Be sure to insert the screws through the
upper and lower slots in the bracket.
2. Align the left rear bracket to the left rear of the switch and use four 8-32 x 5/16-in. panhead screws to
attach the bracket to the switch. Again, use the upper and lower slots in the bracket.
3. Tighten all the 8-32 x 5/16-in. screws to a torque of 15 in-lb. (17 cm-kg).
Attaching rear brackets to the switch
Brocade VDX 6940 Hardware Installation Guide 61
53-1003495-02