Brocade Communications Systems VDX 6940 Series, Hardware Installation Manual, Page: 52 / 136

FIGURE 28 Attaching the short or long rear brackets to the extensions
Attaching the rear brackets to the front rack posts
Complete the following steps to attach the rear brackets to the front rack posts.
1. Attach the right rear bracket to the right front rack post using two 10-32 x 5/8-in. screws and two
retainer nuts, as shown in Figure 29 . Use the upper and lower holes in the bracket.
2. Attach the left rear bracket to the left front rack post using two 10-32 x 5/8-in. screws and two
retainer nuts. Use the upper and lower holes in the bracket.
3. Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lbs (29 cm-kgs).
1 Screws, 10-32 x 5/8-in., panhead
Phillips
2 Retainer nuts, 10-32
FIGURE 29 Attaching the rear brackets to the front rack posts
Universal Two-Post Rack Kit Installation Procedure
Contents
This document provides instructions to install a Brocade 1U or 2U switch in a two-post
telecommunications (Telco) rack using the Universal Two-Post Rack Kit (XBR-R000294).
Attaching the rear brackets to the front rack posts
52 Brocade VDX 6940 Hardware Installation Guide
53-1003495-02