Blue Bird M380 2003, Owner'S Manual

Page: 78 / 579

2-2 – Instruments and Controls - Driver and Co-Pilots Area________________________________M380 Owner’s Manual
2-2-6 Rev. “F”
2-2.9.4.1 Automatic Leg Screens
The leg screens are the “top-level” screens. By repetitively pressing
, you will eventually reach an
AUTO LEG screen. When vehicle operation changes, the screen will automatically change between
Idle, Driving, or PTO. The change will occur immediately or after 5 minutes, depending on whether
“Short Stop Mode” is ON or OFF (Short Stop Mode can only be turned ON or OFF using
INFORM™/INSPEC™ office software). An AUTO LEG screen is one of these three screens. All
examples in this User’s Guide start from an AUTO LEG screen.
2-2.9.4.2 Automatic Idle Display
The top line of the screen shows the present driver and the time. If the Driver ID feature is OFF, only
time will be displayed.
The second line identifies this as the Idle screen.
The third line shows the amount of time the engine has been idling, the percentage of total leg time
the engine has been idling, and performance versus a 20% goal. Plus (+) and minus (-) symbols
indicate performance against this idle-time goal. Therefore, each “+” or “-“ indicates a 2% difference in
actual idle time versus the goal. A “-“ indicates too much time is being spent idling; a “+” indictes
better performance than the goal.
The last time shows heading (on GPS-equipped units) and the remaining time until the engine
automatically shuts down, or how much fuel has been used while idling. This is determined by type of
engine and how the engine is set up.
2-2.9.4.3 Automatic Driving Display
The top line of the screen shows the present driver and the
time. If the Driver ID feature is OFF, only time will be
displayed.
The second line shows Estimated Time of Arrival (ETA)
information. This can be read a: “At your present speed, you
will arrive at 2:45 PM, which is 12 minutes ahead of when you are scheduled to arrive.”
The third line shows how many miles have been traveled on this leg.
The last line shows the average leg fuel economy, and performance versus this average fuel
economy. Each + or - indicates a 10% change in the displayed fuel consumption rate. For example,
++ indicates a fuel rate that is presently 20% better (less than) the rate displayed.