Blue Bird M380 2003, Owner'S Manual

Page: 252 / 579

4-16 – Interior and Exterior Systems Operation - Appliances______________________________M380 Owner’s Manual
4-16-24 Rev. ”G”
PRECAUTIONS FOR PROPER USE:
1. DO NOT leave range unattended while using high temperatures. Automatic fan may start
and provide excessive air to the surface units. This may cause spattering or boil over.
2. Avoid burning food.
3. Keep grease filters clean.
Light
1. To replace light bulbs, first
disconnect power to the oven at
the circuit breaker panel or by
unplugging.
2. To release cover remove the
screw on the light cover. See
illustration.
3. Replace bulbs only with Sharp
Part Number RLMPTA036WRE0
available from a Sharp Service
Center or equivalent 30 watt bulb
available at most hardware stores
or lighting centers. DO NOT USE
A BULB THAT IS LARGER THAN
30 WATTS.
4. Close light cover and secure with
screw removed in Step 2.
CAUTION: Light cover may become very hot. Do not touch glass when light is on. Do not
use light for long time use such as a night light.
Charcoal Filter
Charcoal Filter, Sharp Part Number RK-220 is used for
non-vented, recirculated installation. The filter should
be changed every 6 to 12 months depending on use.
1. Disconnect power to the oven at the circuit
breaker panel or by unplugging.
2. Remove screw from louver. (Top center)
3. Remove louver by inserting flat edge
screwdriver over each tab depressing down
the tab and moving louver away from unit.
4. Pull the louver away from the oven.
5. Slide Charcoal Filter into position on support
tabs.
6. Push louver back into place and gently snap
tabs into place by hand and replace the screw
to secure louver.
Oven Light
Remove the louver per instructions 1-4 above and charcoal filter, if used.
1. Slide the light cover forward and lift up.
2. Remove old light bulb and replace only with Sharp Part Number RLMPTA036WRE0
available from Sharp Service Center or equivalent 30-watt light bulb available from most
hardware stores and lighting centers. DO NOT USE BULB LARGER THAN 30 WATTS.
3. Replace the oven light cover and charcoal filter, if used; push louver back in place and
replace the louver mounting screw.