Blue Bird M380 2003, Owner'S Manual

Page: 145 / 579

M380 Owner’s Manual___________________________________Interior and Exterior Systems Operation - Inverter – 4-5
Rev. “F” 4-5-5
LCD Display – The LCD display is a 16 x 2 lines (32 characters
total) back lit, alphanumeric display, used for setting up the system
operation as well as viewing current status or error messages.
Scrolling through the display items is accomplished by using the
push buttons below the
display. See fig. 4-5.3 .
Push buttons – There are four pressure-sensitive push
buttons on the front panel of the RC7GS used to control the
inverter and enter system operating parameters.
See fig. 4-5.4 .
On/Off – The On/Off push button controls the inverter section of the inverter/charger. Press
this button once to turn the inverter ON or OFF. The charger section of the inverter is not
affected by this function and maintains the batteries whenever ac power is present. On
RC7GS models, this push button also controls the generator. Refer to Generator Start/Stop.
Use this control when you do not want the inverter to supply backup power in the event of an ac line
failure. Ac output power is available only as long as the ac line is present.
NOTE: Pressing this push button disables the inverter function. AC backup power will NOT be
available during a utility outage. The green INVERTER LED must be flashing (with ac utility
applied), indicating the inverter is in a ready state. Pressing this push button while the green
LED is ON solid (indicating backup mode), will cause the loss of the inverter output.
Setup/Menu Item Push button – The Setup/Menu Item push buttons accesses the
system setup menus. Press and hold both push buttons for approximately 5 seconds
or until the display clears, then release the buttons. Press the UP or DOWN arrow
buttons to scroll through the menu items. To exit the Setup mode, press and hold
both push buttons for approximately 5 seconds until the LCD display changes back
to the System Status display.
IMPORTANT NOTE: Should motor home lose battery power, system will revert to default setup
settings. To restore to original settings motor home was delivered with, see
Original Settings
Delivered with Coach chart to assist you.
NOTE: Menu items are described later in this section.
Meter Mode Push button
– The Meter Mode push button (above) accesses the various operating
parameters such as output voltage, amperage, temperature, etc. To access the Meter Mode, press
and hold the Meter Mode push button for approximately 5 seconds.
Settings Push button
– The Settigns push button scrolls through the various menus.
Press this button while in the Setup mode to move through the menu items one at a time. If
the desired item or setting is passed, continue pressing the Settings push button until the
item or setting reappears. This push button is also used to enable and disable the equalize charge
mode.
▲ WARNING: Never attempt to change the presets on the setup mode of remote control panel.
This will not allow the system to function properly.