Blue Bird M380 2003, Owner'S Manual

Page: 170 / 579

4-8 – Interior and Exterior Systems Operation – Awning Operation__________________________M380 Owner’s Manual
4-8-6 Rev. “F”
For proper rafter arm operation the ratchet stud must be correctly installed.
The ratchet stud screws into the tube using a 7/16” wrench and the flat side of the stud should
face the end of the rafter tube.
The off center pin can be pushed up or down using pliers so the cap (and the pin that’s attached
to it) can be re-positioned.
NOTE: The claw opening should face away from the motor home on “Universal Style
hardware and TOWARDS the motor home on Contour Style hardware
.
On contour hardware the ratchet stud should release easily from the counter sunk stop hole at
the top of bar when opening awning.
How to Repair a Bowed Roller
NOTE: This can only be done if there is no crimp or kink in the 3” tube. If the tube is
crimped, it is necessary to replace the tube.
1. Unroll the awning.
2. The awning should be supported and
held at both ends on the shoulders of
two (2) individuals, see Fig. At left. Also,
the awning should be walked in toward
the motor home approximately one (1)
foot, to provide slack in the fabric.
3. Place the bow of the roller facing up.
4. A third person should hang on the tube
at the center point of the bow. Doing this
gradually will remove the bow.
5. To check for straightness, roll the
awning up. If a wobble is present, further straightening is required.
4-8.3 Hardware and Mechanism Maintenance
Although your Zip Dee awning requires less maintenance that any other awning, a little care (about
the same amount that you give to your motor home) will keep the metal parts in top shape. The rafter
arm assemblies, main arm tubes, and the awning case are anodized aluminum; the castings are
high-strength aluminum allows. To keep these parts new looking they should be cleaned once a year
with a good quality non-abrasive chrome or aluminum polish.
The main arm bar and all fasteners and stress bearing shafts are stainless steel. These need only be
cleaned occasionally to remove accumulated grime that might hinder their operation.
At the end of each season:
•
Tighten any loose bolts or screws (Replace missing parts only with factory authorized
replacements).
•
Clean accessible hardware with non-abrasive cleaner.
•
Use a silicone lubricant only on the ½” round shafts that protrude from each end of the roller.
•
Extend all telescoping arms as far as possible to wipe off accumulated sand and dirt that can
clog and scratch the protective aluminum finish. No lubrication is required on those parts.
Replacement Parts
Use only genuine Zip Dee replacement parts when repairs are needed. Use of substitutes may
damage your awning or void your warranty. Parts may be ordered through your local Zip Dee dealer.
If you need help, we are as close as your telephone or post office. Use the number and description