Blue Bird M380 2003, Owner'S Manual

Page: 176 / 579

4-8 – Interior and Exterior Systems Operation – Awning Operation__________________________M380 Owner’s Manual
4-8-12 Rev. “F”
“IN” Adjustment of Lead Rail
Tools Required
•
5mm (3/16”) Allen Wrench
•
Rubber Mallet
This adjustment may be required if the Lead Rail remains out from the awning casing at one end.
The Limit Switches may need to be adjusted. Please see that section entitled
ADJUSTING
MOTOR LIMIT SWITCHES . Otherwise, arms may need to be adjusted as follows:
1. Open the awning about 16 inches.
2. At the selected arm, locate the connection bracket at the forward most portion of the arm at
the Lead Rail ( Item #43 of Exploded View ). Using a 5mm (3/16) Allen Wrench, loosen the
center set screw on this bracket, by ¾ turn, which un-tightens this bracket from the Lead Rail.
This bracket should now be free to slide. Do NOT loosen the offset leveling screw found on
the upper corner of this bracket assembly.
3. Close awning completely and the arms will relocate themselves to the proper location. Re-
open the awning just far enough to re-tighten the arm screws.
Pivotal Adjustment of Lead Rail
Tools Required:
•
5mm (3/16”) Allen Wrench
•
17mm (11/16) Open End Wrench
This adjustment, not being available on earlier models, affects the pivotal angle of the Lead Rail
and is seldom required, as, this angle is factory preset. However, if adjustments are required, the
procedures are:
1. Open the awning about 16 inches.
2. Locate the connection bracket at the forward most portion of the left/rear arm, i.e., the arm
furthest from the motor. ( Item #43 of Exploded View )