Blue Bird M380 2003, Owner'S Manual

Page: 306 / 579

4-18 – Interior and Exterior Systems Operation – Video and Audio Equipment________________M380 Owner’s Manual
4-18-46 Rev. “G”
4-18.3.2 Remote Control
This section shows you how to use the more advanced buttons on the remote control and how to use
the on-screen menus.
NOTE: If you should lose your remote see “ Troubleshooting ” later on in this section.
Button Description
MUTING Instantly turns off the sound. Press again or press VOL to restore sound.
SYSTEM OFF
Powers off all Sony equipment at once, (may not work with older equipment)
TV/VTR
Press when you are finished using a VCR and you want to switch to the TV input. Your VCR
power will remain on.
PICTURE MODE Cycles through the available Video Mode settings.
SLEEP
Turns the TV off automatically in approximately 15, 30, 45, 60, 90, or 120 minutes. Cancel by
pressing until SLEEP OFF appears.
JUMP Alternates between the last two channels selected with the buttons.
TV/SAT
Cycles through available Steady Sound settings.
RESET Press to return to factory settings while in an on-screen menu.
VOL (volume) Press when you want to adjust the volume.
CODE SET
Use to program your remote control to operate connected video equipment.
POWER
Press when you want to turn connected equipment on and off.
FUNCTION Press when you want to control connected equipment on and off.
VCR/DVD (operating)
Operates VCR or DVD. Use when you want to operate connected VCR or DVD with your
remote control.
TV/VIDEO
Cycles through available video inputs.
DISPLAY
Press once to show current time, (if set) and channel number. Press again to turn DISPLAY
off.
MTS/SAP
Cycles through the Multi-Channel TV Sound (MTS) options: stereo, mono, and auto-SAP
(Second Audio Programming).
Change channels directly, and enter numerical values in on-screen displays.
GUIDE
Brings up the custom guide of your satellite receiver.
Moves the cursor in the on-screen menus. Press the arrow buttons to move the cursor. Press
the center button to select or access an option.
MENU Displays the on-screen menu. Press again to exit the menu at any time.
CH (channel) Press when you want to change channels.
4-18.3.3 Setting Up the TV Automatically
After you have finished connecting your TV, you can perform Auto Program to set up your channels.
1. Press
to turn on the TV. The Initial Setup screen appears. See fig. 11 below.
2. Press the TV FUNCTION button.
3. Press
on the remote control or in the TV front panel to perform
Auto Program or press
to exit.