Blue Bird M380 2003, Owner'S Manual

Page: 185 / 579

M380 Owner’s Manual________________________Interior and Exterior Systems Operation – Slide-Out Operation – 4-9
Rev. “F” 4-9-1
4-9 Slide-Out Operation_____
_____________________________
The M380 motor home from Wanderlodge comes with a slide-out room located in the Living
Room/Galley area and an optional slide out room in the Bedroom area. Basic operation of both is
explained below.
NOTE: Transmission shift is disabled if slide room is not fully retracted and locked.
4-9.1 Living Room/Galley Slide-Out with Air Seal
The living room/galley slide room is air actuated with a air seal around the room which deflates when
the room is in motion and only re-inflates when the room is in the fully out position or the fully in and
locked position.
4-9.1.2 Extending The Room:
1. Motor home air must be above 100p.s.i.
2. Parking Brake must be set.
3. Luggage bay doors located below the slide room
must be closed.
4. Level motor home after dumping suspension.
5. Turn ignition switch to the ACC (Accessory)
position.
NOTE: 110V compressor or motor home must
be running to operate slide room.
6. Key next to operator panel in pantry should be
turned to the ON position. The display should read
“Ok to Operate Room” If you do not see this
message check to ensure the above steps have
been met.
7. Push the F1 button to extend room. You must hold button down until room is fully extended.
The room is extended when the display reads “Room is Extended”. This will be followed by
the message “Seal Inflating” then “Ok to Operate Room”.
8. Turn keys off.
4-9.1.3 Retracting The Room:
1. Motor home air must be above 100p.s.i.
2. Parking Brake must be set.
3. Luggage bay doors located below the slide room must be closed.
4. Verify the motor home is still level.
5. Turn ignition switch to the ACC position.
NOTE: 110V compressor or motor home must be running to operate slide room.
6. Key next to operator panel in pantry should be turned to the ON position. The display should
read “Ok to Operate Room” If you do not see this message check to ensure the above steps
have been met.
7. Push the F2 button to retract room. You must hold button down until room is fully retracted.
The room is retracted when you get a signal “Room is Retracted”. This will be followed by
“Seal Inflating” then “Ok to Operate Room”.
8. Turn keys off.
NOTE: F3 and F4 buttons are for service use only. DO NOT USE.