Blue Bird M380 2003, Owner'S Manual

Page: 173 / 579

M380 Owner’s Manual__________________________Interior and Exterior Systems Operation – Awning Operation – 4-8
Rev. “F” 4-8-9
5. Push the button during either the extend or retract mode to STOP the awning at any desired
position. The button can also be used to change direction of the awning by pushing it twice.
NOTE: The motor supplied with your Girard G-2000 Awning is a high torque/low RPM motor,
and has been carefully selected for its reliability and application compatibility. It is designed
for intermittent use with a rating of 4 minutes/hour. If the motor’s run-time exceeds this time
period, a built-in circuit breaker will disable the motor from operation. This condition indicates
normal operation of your awning system, and generally only occurs during excessive
adjustment periods. If this condition should occur, please allow sufficient time (up to one
hour, depending on the outside temperatures) for the motor to reset and use the manual
override feature.
Wind Sensor Function
The Wind Sensor V Controller, and the Wind Sensor V Anemometer work together to continuously
monitor the wind speeds, at any given minute, around your awning. If the actual wind speed becomes
GREATER than the wind speed setting of your controller, a two (2) second delay occurs, and a signal
is sent to the awning motor to retract the awning. THE AWNING WILL REMAIN IN THE RETRACTED
POSITION UNTIL SUCH A TIME THAT IT IS ONCE AGAIN EXTENDED BY PRESSING THE
BUTTON OF THE SWITCH PANEL.
Adjusting the Wind Speed Setting
The Wind Sensor V has been factory pre-set to a maximum wind speed of 22 MPH. Under no
circumstances should this level be set at higher speeds. It is recommended, however, that you
become familiar with the location of your Wind Sensor Control Box. It is usually located inside of an
upper cabinet. In the event that you wish to reduce the pre-set wind speed, locate your control box
and remove the four (4) Phillips screws that secure the cover. Remove the cover and notice the small
dial located near the center of the box. This dial should be pointed at 22. The minimum setting will be
approximately 12 MPH.
4-8.4.4.3 Remote Control Programming
Normally, your remote control will
come pre-programmed. However,
if it is not, follow this procedure:
1. On the Control Box
•
To put the receiver in
its programming
mode, press the
PROGRAM button
and hold, until the
LED lights up and
then release. The
Programming Button
is located on the PCB
Board inside the
control box.
•
The receiver is now
ready to memorize any transmitter/channel for a period of one (1) minute.
2. On the Transmitter
•
Press the Programming Button on the back of the transmitter. After one (1) minute, or
once the receiver is programmed, the LED goes off. The transmitter is now programmed.
•
To verify the program, press the DOWN button to make sure that the awning is
extending. If it does not, repeat the instructions from number one (1) above.