Blue Bird M380 2003, Owner'S Manual

Page: 41 / 579

M380 Owner’s Manual____________________________________________Safety and Security - Security Features – 1-2
Rev. “F” 1-2-9
(glow plug input) is monitored to make sure the glow plugs have warmed up before the engine begins
cranking. If the glow plug wire is not connected, the unit has a built-in timer that waits 15 seconds
before cranking the starter.
Complete Default Reset
Following this procedure will set all User and Installer Programming Parameters to factory default
settings.
1. Enter System Programming.
2. Press Transmitter Button 3.
•
The siren will chirp 6 times indicating the reset signal was received.
•
All Programming options are now set to factory default settings.
3. Turn ignition off.
Test System and Adjust Shock Sensor
Arm, disarm, and start the system, checking that the siren and parking lights are functioning normally.
Make sure that the programmed features are performing correctly, ie.: ignition locks, passive arming,
passive locks, etc.
1. Test the doors and bay door inputs (make sure all doors trigger the system.)
2. Adjust the shock sensor. (
see Real-time Sensor Adjustment Mode ).
3. Arm the system and disarm it with the ignition and valet switch.
4. If programmed to passively arm make sure that the system arms properly.
5. Tie up wire harness, and replace any under dash panels.
6. Make sure the customer has physical knowledge of the location of the valet/override switch.
Real-time Sensor Adjustment Mode
This mode allows active testing of the shock sensor and optional sensor input making adjustments
without arming the alarm.
NOTE: Arm and Disarm chirps must be enabled for proper operation. Sensor Adjustment
Mode does not operate with the optional FM transmitter.
To Enter Sensor Adjustment Mode:
1. Turn the ignition on.
2. Press the Shift Button (Button 5) 3 times, then press Button 3.
•
The siren will chirp 4 times, indicating that the sensor is ready to be tested.
3. Test the sensitivity. The siren will chirp to indicate a sensor is triggered.
•
One chirp indicates the shock sensor.
•
Two chirps indicates the warn away.
•
Three chirps indicates the optional sensor.
4. To make shock sensor adjustments:
•
Turn the adjustment screw on the sensor clockwise to increase the sensitivity.
•
Turn the adjustment screw on the sensor counter clockwise to decrease the sensitivity.
5. Turn off the ignition when the desired sensitivity level is reach.
Adding Transmitters
To add a new transmitter to the system have the desired transmitters ready and follow the Code
Learning sequence.
To Enter Code Learning Mode:
1. Turn the ignition on, off, on, off and leave on.
•
The siren will chirp.
2. Press the Override switch.
•
The status LED will turn on red.
•
The siren will chirp.
3. Press the Lock Button on the transmitter.
•
The siren will chirp once.
4. Press Lock Button on the transmitter again.
•
The siren will chirp twice.
5. Repeat steps 3 and 4 for each additional
transmitter.
6. Turn off the ignition.
•
The siren will chirp 3 times.