Partner Management
41
User’s Guide: Version 1.2
waddpartners.add
This menu is where you add (or change) ISDN partner configurations. If
you are editing an existing partner, the current settings are displayed. If
you’re adding a new ISDN partner, the default values for a dialup IP part-
ner are shown.
Partner Name
= Enter a unique name to identify your partner. If the
ISDN partner is a BIANCA/BRICK, this should be set to the BRICK’s
hostname.
Enabled Protocols
= Depending on the type of traffic you will be
routing with this partner, select the protocols the link to this partner
will support.
Encapsulation
= Defines the type of encapsulation to use over this
link. Depending on which protocols you enabled for this partner, the
available encapsulation methods will vary.
Also note that encapsulations using STAC compression are only avail-
able if STAC is licensed on your V!CAS.
See the table below for encapsulation characteristics.
V!CAS Setup Tool
BinTec Communications GmbH
[
WAN
][
ADD
]
: Configure WAN Partner
vicas
Partner Name
Enabled Protocols
<X> IP < > IPX < > BRIDGE < > X.25
Encapsulation
PPP
Identify by Calling Number
no
PPP Authentication Protocol
CHAP and PAP
Partner PPP ID
Local PPP ID
vicas
PPP Password
ISDN Numbers >
IP >
IPX >
Advanced Settings >
SAVE
CANCEL
Enter string, max length = 25 chars
ADD
WAN P
ARTNER
