152
ISDN Connections
V!CAS
ipxAdmSpxConns
shows more connections than are actually
present.
The V!CAS may not be receiving SPX disconnect messages from the serv-
er.
• Using the command “reset router” on the console of the respective
server, any inactive connections between the server and the V!CAS
are closed.
• If the disconnect for the client is lost, the connection will eventually
timeout and close. Until the timeout, the connection is displayed in
the ipxAdmSpxConns. Once the connection does close, SPX sends a
message to the server informing it that the connection is closed.
ISDN Connections
This section covers some of the problems you may encounter when cofig-
uring ISDN connections and suggests where to look first for possible so-
lutions. The following sections give instructions on using the available
utilities and programs to check your ISDN configurations.
Outgoing calls do not connect.
• Verify the call is connected by viewing the front plane LEDs. Refer
to Chapter 8 for meanings of the front panel indicators.
• Check to see if outgoing calls are possible by using the isdnlogin
program.
Check the isdnCallHistoryTable.
• Was an outgoing call logged at all?
• Was the dialled number correct (see biboDialTable)?
• Was the call connected (duration > 0)?
Check the biboAdmSyslogTable.
• Check for syslog messages from ISDN with a “disconnect cause”.
