Configuring Protocols
55
User’s Guide: Version 1.2
ip.routing.add
Use this menu to add (or make changes) to the IP routing table.
Route Type
= The type of IP route you’re adding, i.e. a route to a sin-
gle host or network. If a default route is specified it will only be used
when no other matching routes are found.
Network
= Use LAN for hosts (or nets) directly attached to the V!CAS.
For routes that use WAN interfaces, specify whether the route in-
cludes transfer network. If “discard” is used the V!CAS disregards all
packets matching this route.
Transit Networks
: Some sites may require an intermediate transit
network (mainly sites using routing equipment from different
manufacturers). As shown below, each host on the transit network
is accessible via two different addresses.
V!CAS Setup Tool
BinTec Communications GmbH
[
IP
][
ROUTING
][
ADD
]
: Add or Change IP Route
vicas
Route Type
Host route
Network
WAN without transit network
Destination IP-Address
200.1.1.2
Partner / Interface
partnerbrick
Metric
1
SAVE
CANCEL
Use <Space> to select
IP
R
OUTING
ADD
200.1.1.1
200.1.1.2
199.1.1.1
199.1.1.2
201.1.1.1
201.1.1.2
Transit
Network
ISDN
