12
Logging in for the first time
V!CAS
In BOOTmonitor mode, the V!CAS waits 4 seconds for the user to
press the spacebar which activates the BOOTmonitor. See BOOTmonitor,
page 169, in Chapter 8 for information on using the BOOTmonitor.
Normal Operation Mode is entered once the V!CAS is finished booting
its internal system software.
Normally, the whole process only takes about 15 seconds. You can see
the results of the various tests on your terminal display.
After the system comes up, the V!CAS starts various system daemons
depending on which features are licensed on your V!CAS. The system
then presents a login prompt to the screen of a connected serial console.
Logging in for the first time
To log into the V!CAS for the first time;
enter
admin
at the login prompt, then
enter
bintec
when prompted for a password.
Note that the V!CAS uses three different login names and passwords
to grant various levels of access to configuration information. These user
### V!CAS - Start-up ###
Starting DRAM Test : ................................ ok.
Starting FLASH Test : .... [0xc3b2] ok.
Starting ISDN Chip Test : .... ok.
Starting ISDN Loopback Test : .... ok.
Starting ISDN Bus Test : .... ok.
Starting Ethernet Chip Test : .... ok.
Starting Ethernet Loopback Test M1: .................... ok.
Starting Ethernet Loopback Test M2: .................... ok.
### V!CAS (Hardware Release 1.2, Firmware Release 1.7) ok ###
Press <sp> for boot monitor or any other key to boot system
Booting Image from Flash ROM
Checking image ... OK
Writing image to RAM (Release 4.6.1) .......................OK (1396684 bytes)
Booting BOSS...
BOSS kernel v2.0 (V!CAS)
Copyright (c) 1996 by BinTec Communications GmbH
Version 4.6 Revision 1 from 97/10/01 00:00:00
The system is coming up.
The system is ready.
