BOOTmonitor
171
User’s Guide: Version 1.2
Delete
Configuration
You can select option (4) to return the V!CAS to its factory settings, as it
arrived. All configuration files and BOOTmonitor settings (see Default
BOOTmonitor Parameters below) will be removed.
Default
BOOTmonitor
Parameters
By selecting option (5) from the menu you can set or change the default
settings used by the BOOTmonitor. The following default settings can be
defined:
•The baud rate used for connecting a terminal.
•Which LAN interface to use for TFTP file transfers
(when more than 1 are present).
•The IP address for the V!CAS
•The IP address for the TFTP server
•The image file to load/retrieve
•Automatic boot file retrieval over TFTP
The IP address settings defined here are used strictly for the BOOT-
monitor and are not used for any IP routing functions on the V!CAS.
Note:
Note that option (2) only loads the image into RAM and
does not remove your existing boot image stored in Flash.
In this way, you can test the new software release without
removing your existing boot image. If the V!CAS is turned
off, your old software release will be used upon a subse-
quent reboot.
!
Note:
If you change the baud rate, be sure that your terminal sup-
ports this rate, otherwise you may not be able to connect to
the V!CAS. The default setting is set at 9600 baud, which is
supported by practically all terminals.
!
PWR
