Important Safeguards
This section describes the safety precautions the user should abide by when op-
erating this equipment.
• Transport this equipment in its original
packaging or by using appropriate mate-
rials to prevent against shock and impact.
• Before setting up this product for opera-
tion please make note of the accompa-
nying environmental requirements.
• Slots and openings in the unit are provid-
ed for ventilation. To ensure reliable oper-
ation and to protect it from overheating
these slots and openings must not be
blocked or covered.
• Condensation may occur externally or in-
ternally if this equipment is moved from a
colder room to a warmer room. When
moving this equipment under such condi-
tions, allow ample time for the equipment
to reach room temperature and to dry
before operating.
• Note that normal operation (in accord-
ance with IEC 950/EN-60950) is only possi-
ble when the external housing is left in
place (ventilation, fire prevention, and ra-
dio interference).
• Before supplying power, verify the power
rating identified on the marking label
complies with the local power source. This
equipment may be operated under the
following conditions:
100 - 240 VAC
50 - 60 Hz
max. 0.2 A
• Do not allow anything to rest on any of the
attached cables and do not locate the
product where persons will walk or trip on
the cables.
• Connect this equipment only to an ap-
proved, properly grounded, and accessi-
ble socket outlet (this product includes a
safety tested power cable). To complete-
ly turn off this equipment you must remove
the power cord from the system.
• Avoid connecting or disconnecting data
lines during lightning storms.
• Follow the accompanying instructions
when connecting the required cabling.
• Make sure no foreign objects or liquids
come into contact with the internal com-
ponents (danger of shock or short circuit).
• In an emergency (e.g., damaged exter-
nal housing or internal elements, liquid
spills) immediately remove the power
cord and notify customer service.
• Use only the supplied cables. If you use
other cables BinTec Communications
cannot assume responsibility for any re-
sulting damage.
• Electrostatic electricity can damage in-
ternal components. Ground yourself be-
fore touching any internal components.
• Never use water to clean this device. If
water reaches the internal parts, extreme
danger may result to the user or the
equipment.
• Never use scouring or abrasive cleaning
agents, or agents containing alkaline on
this device. Damage to the device’s exte-
rior may result.
•
NOTICE: The safeguards listed here apply
to all countries. A description of these
safeguards in your local language can be
found in Appendix A.
