Bay Alarm Vista-20Bay, Installation And Setup Manual

Page: 47 / 138

Section 8 - 4285/4286 VIP Module
8–3
4285/4286 VIP MODULE WIRING NOTES:
•
Wire the phone module exactly as shown, using a direct-connect cord and RJ31X jack.
•
If you do not hear touch-tones when pressing keys after phoning the security system via an on-
premises phone, try reversing the pair of wires connected to terminals 3 and 4 on either phone
module
and
the pair of wires connected to terminals 21 and 22 on the control.
•
If you hear an error signal (fast busy signal) when trying to access the system via the premises
phone, check for correct line seizure wiring.
You must connect the incoming telco line via an RJ31X jack and direct-connect cord, as shown in
this diagram, even if the system is not connected to a Central Station.
The 4285 or 4286 VIP
module will not function if this is not done.
The house phone lines (gray and brown wires) must be wired to the phone module terminals, not
to the control terminals. Otherwise, an error signal (fast busy signal) will occur when you try to
access the system from an on-premises phone.
•
If the telephone system on the premises includes a Caller ID unit, connect the unit
directly
to the
Handset terminals (21 and 22) on the control, as shown below.
22
ANSWERING
MACHINE
TERMINALS
ON CONTROL
TO EARTH GROUND (COLD WATER PIPE, ETC.)
➡
SPEAKER VOLUME
ADJUSTABLE ON
4286 ONLY
UNUSED
KEYED
HEADER
▲
▲
4285 or 4286
VIP MODULE
1
2
345
6
7
YELLOW: TO DATA OUT (term. 7)
NO CONNECTION
RED:
TO AUX (+) (term. 5)
BLACK: TO AUX. GROUND (–) (term.4)
GREEN:
TO DATA IN (term. 6)
CONNECTOR
WITH FLYING
LEADS
TO CONTROL
PANEL
TERMINALS
USED FOR
KEYPAD
CONNECTIONS
➡
PREMISES ANSWERING
MACHINE AND PHONES
Handset
Incoming
Teleco Line
TIP RING
RJ31X
JACK
PLUG
DIRECT
CONNECT
CORD
➧
TIP
RING
GR
OUND
MUST CONNECT
T
O
ON 4285
(TIP)
MUST CONNECT
T
O
ON 4285
(RING)
GREEN (TIP)
RED (RING)
1
2
▲
▲ ▲
INCOMING TELECO LINE
GRAY (R) BR
O
WN (T)
4285/4286 VIP MODULE
TERMINAL ASSIGNMENTS
1 - TIP
2 - RING
PHONE INPUT
3 - TIP
4 - RING
PHONE OUTPUT
5 - NO CONNECTION
6 -
7 -
AUDIO OUT
(4286 ONLY)
}
}
}
▲
{ {
IMPORTANT NOTE FOR
EXISTING INSTALLATIONS:
EXISTING WIRES
CONNECTED TO THE
"HANDSET" TERMINALS ON
CONTROL MUST BE MOVED
FROM THERE TO TERMINALS
3 AND 4 ON THE 4285.
21
23 24
CALLER ID
UNIT
*
*
*
NOTE: IF THE TELEPHONE HAS BUILT-IN CALLER ID,
THE CALLER ID FUNCTION MAY NOT WORK .
25
CA38A IN
CANADA
IMPORTANT!
IF THE PANEL IS NOT CONNECTED TO A
PROPER EARTH GROUND, YOU MAY
GET FALSE LINE CUT INDICATIONS (IF
TELEPHONE LINE MONITOR HAS BEEN
PROGRAMMED).
Figure 16. 4285/4286 VIP Module Wiring Connections