Bay Alarm Vista-20Bay, Installation And Setup Manual

Page: 70 / 138

VISTA-20BAY Installation & Setup Guide
16–2
✱
25 WIRED ZONE EXPANSION
0
0 = no expander module connected
1 = 4219 connected
2 = 4229 connected
3 = 4204 connected
✱
26 CHIME BY ZONE
0
0 = no (chimes on fault of any entry/exit or perimeter zone when chime mode
activated)
1 = yes (chimes on fault of specific zones programmed in relay zone list 3
when chime mode activated)
This option allows the installer to define the specific zones intended to chime
when faulted while the system is in chime mode.
✱
27 POWERLINE CARRIER DEVICE (X-10) HOUSE ID
0
Powerline Carrier devices require a House ID. This field identifies this House
ID to the control.
If Powerline Carrier devices are used, they are selected in field
✱
80.
House ID is entered in following manner:
0 = A, 1 = B, 2 =C, 3 = D, 4 = E, 5 = F, 6 = G, 7 = H, 8 = I, 9 = J,
# + 10 = K, # + 11 = L, # + 12 = M, # + 13 = N, # + 14 = O, # + 15 = P.
✱
28 PHONE MODULE ACCESS CODE
0 | 0
1-9 = first digit of access code
✱
or # = second digit of access code (enter # +11 for “
✱
”, or # +12 for “#”)
The use of a 4285/4286 VIP Module requires a 2-digit code.
Example:
If desired access code is 7
✱
, 7 is the first entry, and [#] + 11 (for
✱
)
is the second entry.
NOTE: A “0” in either digit disables the phone module.
✱
29 OUTPUT TO LONG RANGE RADIO (7720PLUS/7820/7835C)
0
If you select output to Long Range Radio (LRR) here, all messages that are
programmed to go to the primary telephone line receiver will also be sent to
either the 7720PLUS, 7820, or 7835C radio. These messages will always be in
Contact ID format (not affected by entry in field
✱
48). The data line is
supervised as well as certain functions in the radio. If communication is lost
or a trouble develops, an attempt will be made to send a message via both
radio and telephone to the Central Station.
NOTE: Normal Trouble Restore report (
✱
71) is sent upon restoration of the
condition.
Entry is first digit of “Trouble Dialer” report; enter Trouble code 1-9,
B (# +11), C (# +12), D (# +13), E (# +14), or F (# +15). The 2nd digit of Trouble
Dialer report is automatically the 2nd digit from field
✱
60.
UL
For all UL installations, the digit entered (or defaulted) must be 0 to disable the Long Range
Radio.
NOTE: The radio should be programmed for device address 3 on the keypad
lines.