Bay Alarm Vista-20Bay, Installation And Setup Manual

Page: 77 / 138

Section 16 - Data Field Descriptions
16–9
If Contact ID format has been programmed, the message contains the zone
number and error code 374 (Trouble-Exit Error) to define the alarm as an Exit
Error (rather than E/E or Interior). If 4+2 format is used, the digit entered in
this field is sent, followed by the second digit of the programmed alarm code
for that zone. If 3+1 or 4+1 format is used, only the digit entered in this field
is sent. This message goes to the Primary Phone Number. Under any of these
conditions, no Restore message is sent.
If you enter 0 in this field, no special message is sent, only the regular Alarm
and Alarm Restore code for the zone.
✱
60 TROUBLE REPORT CODE (See box on previous page)
0 | 0
This code is sent if a zone goes into trouble.
✱
61 BYPASS REPORT CODE (See box on previous page)
0 | 0
This code is sent when a zone is manually bypassed (or forcibly bypassed
as programmed in
✱
23).
✱
62 AC LOSS REPORT CODE 0 | 0
See box on previous page. Reports with Subscriber No. Timing of this report
is random with up to a 4-hour delay. If AC restores before the report goes out,
there is no AC Restore report.
✱
63 LOW BAT REPORT CODE
0 | 0
This code is sent when a low-battery condition exists in the system’s standby
battery. See box on previous page. Reports with Subscriber Number.
✱
64 TEST REPORT CODE
0 | 0
This code is sent periodically to test that the communicator and phone lines
are operational (frequency of report is selected in field *51). See box. Reports
with Subscriber Number.
✱
65 OPEN REPORT CODE
0
This code is sent upon disarming of the system. See box. 2nd digit = user
number, if expanded or 4+2 reporting is selected.
✱
66 ARM AWAY/STAY REPORT CODE
0 | 0
AWAY STAY
This option allows for independent programming of AWAY and STAY reports.
2nd digit of report is user number if expanded or 4+2 reporting is selected.
NOTE: Open reports are not sent if the associated Closing report is not
enabled. Arming the system in MAXIMUM mode generates an AWAY
report; arming the system in the INSTANT mode generates a STAY
report.
✱
67 RF XMTR LOW BAT REPORT CODE (See box on previous page)
0 | 0
This code is sent in the event that a wireless transmitter
low-battery condition exists.
✱
68 CANCEL REPORT CODE (See box on previous page)
0 | 0
This code is sent upon disarming of the system after an alarm condition is
reported.
RESTORE
REPORT CODES
( ✱ 70- ✱ 76)
✱
70 ALARM RESTORE REPORT CODE, 1st digit
0
This code is sent when the zone that caused an alarm is restored to its
nonfaulted condition. If Expanded or 4+2 reporting is selected, 2nd digit is
automatically sent as the 2nd digit of the zone Alarm Report code
programmed in field
✱ 56 or ✱ 58.