Bay Alarm Vista-20Bay, Installation And Setup Manual

Page: 75 / 138

Section 16 - Data Field Descriptions
16–7
✱
53 SESCOA/RADIONICS SELECT
0
0 = Radionics (0-9, B-F reporting)
1 = SESCOA (0-9 only reporting)
Select 0 for all other formats.
DYNAMIC
SIGNALING
(
✱
54 -
✱
55)
✱
54 DYNAMIC SIGNALING DELAY (DSD) 0
This field enables you to select the time the panel should wait for
acknowledgment from the first reporting destination before it attempts to
send a message to the second destination. Delays can be selected from 0 to
225 seconds, in 15-second increments. This delay is per message.
1 = 15 seconds, 2 = 30 seconds, 3 = 45 seconds, etc.
Default is 0 (no delay). You must enter 0 for UL installations.
NOTE: If you enter 0 in this field, the control panel sends redundant reports
to both Primary phone number and LRR.
✱
55 DYNAMIC SIGNALING PRIORITY (DSP) 0
This field enables you to select the initial reporting destination for messages,
Primary Phone Number or Long Range Radio.
0 = Primary Phone Number first; 1 = Long Range Radio (LRR) first.
Default is 0 (Primary Phone Number)
The following chart illustrates how the Dynamic Signaling feature functions.
If DSP (
✱
55) is:
And message is: Then:
acknowledged before
delay expires (from
✱ 54 above),
message is removed
from queue and no
message is sent to LRR. Primary Phone
Number
(0 entered),
not acknowledged
before delay expires, message is sent to both
the Primary Phone
Number and LRR.
acknowledged before
delay expires (from
✱
54 above),
message is removed
from queue and no
message is sent to
Primary Phone Number.
Long Range
Radio
(1 entered),
not acknowledged
before delay expires, message is sent to both
the Primary Phone
Number and LRR.
NOTE: You must enable field
✱
29, OUTPUT TO LONG RANGE
RADIO, if this feature is to function.
ZONE ASSIGNMENT
ALARM REPORT
CODES
(
✱
56 &
✱
58)
✱
56 ZONE PROGRAMMING MODE
Interactive Menu mode used for enrolling transmitters, programming zone
attributes, and report codes. Refer to
Section 17: Zone Programming for
procedure.