Bay Alarm Vista-20Bay, Installation And Setup Manual

Page: 96 / 138

VISTA-20BAY Installation & Setup Guide
18–4
CHOICES FOR ZONE TYPES
00 = Not Used 04 = Interior Follower 08 = 24-Hr Aux
01 = Entry/Exit #1 05 = Trouble Day/Alarm Night 09 = Fire
02 = Entry/Exit #2 06 = 24-Hr Silent 10 = Interior w/Delay
03 = Perimeter 07 = 24-Hr Audible 24 = Silent Burglary
CHOICES FOR SYSTEM OPERATION
20 = Arming–STAY 33 = Any Burglary Alarm 41 = AC Power Failure
21 = Arming–AWAY 36 = At Bell Timeout
†
42 = System Battery Low
22 = Disarming (Code + OFF) 38 = Chime 43 = Communication Failure
31 = End of Exit Time 39 = Any Fire Alarm 52 = Kissoff
32 = Start of Entry Time 40 = Bypassing 58 = Duress
†
Or at Disarming, whichever occurs first.
02 Stop: Zn List
No List 0
If a zone list will be used to STOP, or
restore
, the device action,
enter the zone list number
1
,
2
, or
3
(to be programmed in
✱
81
mode). If not used, enter
0
.
Press [
✱
] to continue.
02 Stop: Zn Typ
Not Used 00
If a zone type or system operation will be used to STOP the device
action, enter the appropriate 2-digit code (refer to the “
CHOICES
FOR ZONE TYPES ” listed above). If not, enter
00
. Press the [
✱
]
key to continue.
02 A EV ZL ZT
−
STT 0 0 0 00
−
This screen again displays a summary of the current device START
programming. Press [
✱
] to continue.
02 A EV ZL ZT
−
STP – – 0 00
−
This screen again displays a summary of the current device STOP
programming. Press [
✱
] to continue.
02 X10 Device ?
0 = No, 1 = Yes 00
Enter 1 if you are using a Powerline Carrier device (X-10); if not,
enter
0
.
The display then returns to the first screen so that you can enter
the next device number to be programmed, or enter
00 to end device
programming.
Example of
Output Device
Programming Assume that a lamp is to be turned on via a Powerline Carrier
device (X-10) when any one of 3 specific zones are faulted, or when
any 24-hour auxiliary zone is faulted. Additionally, assume that you
want to be able to turn off the lamp
manually without affecting the
arming status of the system.
To program the above example, do the following:
1. In
✱
80 Interactive mode, choose Output Device 01 and program
the ACTION (A) to be “2” (Stay Closed). Press [
✱ ] to continue.
The Event you want to START the device action is a fault, so
program
2 in (EV). Press [
✱ ] to continue.
To use Zone List 1 for the 3 specific zones, program 1 in (ZL), and
program these 3 zones in
✱
81's Zone List 1. Press [
✱
] to continue.