Bay Alarm Vista-20Bay, Installation And Setup Manual

Page: 45 / 138

8–1
S E C T I O N 8
4285 & 4286 VIP Module
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
In This Section
♦
Introduction
♦
Installing the Phone Module
♦
Programming the 4285/4286 VIP Module
♦
Checking 4285/4286 VIP Module Operation
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
Introduction
This section provides instructions for mounting and wiring the 4285 or 4286 VIP Module.
Installing the Phone Module
General Information
The 4285 or 4286 VIP Module is an add-on accessory for the VISTA-20BAY that permits
access to the security system via a TouchTone phone (either on-premises or by a call-in when
away). The 4286 VIP Module has the additional capability of controlling thermostat(s) and
providing external speaker output.
The phone module can announce many of the same words that would normally be displayed
on an alpha keypad under the same system conditions.
• Only one phone module can be used in this security system.
When properly connected, the 4285/4286 VIP Module enables the user to do the following via
a TouchTone telephone:
a. Receive synthesized voice messages over the phone regarding the status of the security
system.
b. Arm and disarm the security system and perform most other commands using the
telephone keypad, with voice annunciation over the phone confirming any command that
is entered.
The phone used for phone access must have TouchTone capability, though TouchTone service
is not necessary. (If premises uses pulse dialing, switchable phones must be set for
TouchTone temporarily before attempting phone access.)
A Phone Access User's Guide for phone access to the security system is provided with the
phone module for the user of the system.
Mounting the 4285 or 4286 VIP Module
The phone module may be mounted in the control cabinet if space is available or, if this is not
possible, on the side of the cabinet or adjacent to it.
When mounting the module outside the cabinet, use the screw holes at its rear, which
permits it to be mounted horizontally or vertically (2-faced adhesive tape may be used, if
preferred). Wires can be brought out from the side or back (a round breakout is also available
on the back).