Bay Alarm Vista-20Bay, Installation And Setup Manual

Page: 78 / 138

VISTA-20BAY Installation & Setup Guide
16–10
✱
71 TROUBLE RESTORE REPORT CODE
0 | 0
See box on previous page. This code is sent when a trouble in a
zone is restored.
✱
72 BYPASS RESTORE REPORT CODE
0 | 0
See box. This code is sent when a zone that has been bypassed is unbypassed.
✱
73 AC RESTORE REPORT CODE
0 | 0
This code is sent when AC power has been restored after an AC power outage.
See box. Reports with Subscriber Number.
✱
74 LOW BAT RESTORE REPORT CODE 0 | 0
Refer to box on page 16-8. This code is sent when a system low-battery
condition is restored to normal. Reports with Subscriber Number.
✱
75 RF XMTR LOW BATTERY RESTORE CODE 0 | 0
Refer to box on page 16-8. This code is sent when a transmitter that
previously sent in a Low-Battery message has sent a message indicating it no
longer has a low-battery condition.
✱
76 TEST RESTORE REPORT CODE
0 | 0
This code is sent when the Test mode is exited. See box. Reports with
Subscriber No. A restore code entered here causes a Restore message to be
sent when Test mode is exited.
✱ 80 OUTPUT DEVICES
Interactive Menu mode applicable only if field ✱ 25 is programmed for a 4229
or 4204; or if Powerline Carrier devices are being used. Refer to Section 18:
Output Device Programming for detailed procedure.
✱
81 ZONE LISTS FOR OUTPUT DEVICES
Interactive Menu mode applicable only if ✱ 25 is programmed for a 4229 or
4204; or if Powerline Carrier devices are being used. Refer to Section 19:
Zone Lists for detailed procedure.
✱
82 CUSTOM ALPHA EDITING
Interactive Menu mode used to program zone descriptors. Refer to Section
20: Alpha Descriptor Programming for procedure.
✱
88 PAGER CHARACTERS
When programmed in field
✱
49, reports will be sent to the pager depending
upon the number selected.
| | | | | | | | | | | | | | |
This programming field (
✱
88) allows up to 16 digits to be entered to signal a
pager. For example, these optional 16 digits may be composed of the following:
•
PIN number (to identify a specific pager to the paging company)
•
Subscriber account number
•
✱ (enter # + 11 to send ✱
)
•
# (enter
# + 12
to send #
)
•
Pause (enter
# + 13
to allow a 2-second pause)
•
Any special character(s) the end user may decide to transmit
All 16 digits do not have to be used.
The preceding 16 digits (if any) are followed by a 7-digit Pager Format,
which is defined as follows: | | | | | |