Bay Alarm Vista-20Bay, Installation And Setup Manual

Page: 76 / 138

VISTA-20BAY Installation & Setup Guide
16–8
✱
58 EXPERT PROGRAMMING MODE
Interactive Menu mode used for enrolling transmitters, programming zone
attributes, and report codes. Refer to
Section 17: Zone Programming for
procedure.
TO PROGRAM
SYSTEM STATUS
AND RESTORE
REPORT CODES
Report codes can be programmed using the interactive
✱
56 Zone Programming mode
or
✱
58 Expert Programming mode, and codes can be entered in data fields
✱
59
through
✱
76, and
✱
89.
The following is a set of guidelines to be used for programming Report codes. The
actual Report code digits that you enter depend upon the particular installation, and
should agree with the Central Station office receiving the signals. Use these
guidelines to program this entire section.
With a 3+1 or 4+1 Standard Format:
Enter a code in the first box: 1-9, A, B, C, D,
E, or F. Enter “#+10” for A (this reports a “0” on some receivers), “#+11” for B,
“#+12” for C, “#+13” for D, “#+14” for E, “#+15” for F.
An entry of “0” in the first box disables a report.
An entry of “0” in the second box results in automatic advance to the next field
when programming.
With an Expanded or 4+2 Format: Enter codes in both boxes (1st and 2nd digits)
for 1-9 or A-F, as described above.
An entry of “0” in the first box disables a report.
An entry of “0” in the second box eliminates the expanded message for that
report.
With ADEMCO Contact ID Reporting: Enter a digit in the first box to enable the
zone to report. Use a different digit for each zone until you have used up available
digits. If the number of zones exceeds the number of available digits, begin with
digit 1 again. This is an “enabling” code only and is not the actual code sent to the
Central Station office. Entries in the second boxes will be ignored. For System
Status (nonalarm) codes, enter a “1” in the first box for all the system conditions you
want to send to the Central Station.
An entry of 0 in the first box disables the report.
SYSTEM STATUS
REPORT CODES
(
✱
59-
✱
68)
✱
59 EXIT ERROR REPORT CODE (See box above)
0
If the system is armed and an entry/exit or interior zone is still open after the
Exit Delay time has expired, an alarm sounds at the keypad and external
sounder (keypad also displays
EXIT ALARM
). If the system is disarmed
before the end of the Entry Delay that immediately follows, the alarm
sounding stops and no message is sent to the Central Station. The keypad
displays
CA
(on fixed-word keypads) or
CANCELED ALARM
(on alpha
keypads).
If the system is
not disarmed before the end of the entry delay mentioned
above, and an entry/exit or interior zone is still open, an Exit Alarm message
is sent to the Central Station if an Exit Error Report code is selected in this
field. The keypad displays
EA (on fixed-word keypads) or EXIT ALARM (on
alpha keypads), and the alarm sounding continues until the system is
disarmed (or timeout occurs).
An
EXIT ALARM
condition also results if a fault occurs in an exit or interior
zone within 2 minutes after the end of the exit delay, and an Exit Alarm
message is sent to the Central Station.