48
DCU 410 Engine Panel Installation
400 Series Installation and Configuration
Requires Running Engine
Select Yes if the switch normally changes state
when the engine goes from standstill to running,
or vice versa.
This means the switch will alarm only when the
DCU senses the engine is running.
Typical setting: Set to Yes for all pressure switches.
Several different RPM set points are available.
Requires In-Gear
This means the switch will alarm only when the
DCU has a high input on In-gear input.
Requires Engine Load
This means the switch will alarm only when the
DCU has reached the configured % load.
Initial Delay
Note! Available only if On Run Only is selected.
The switch event is disabled for this many seconds
after the engine is running. After the timer has
elapsed, the channel is enabled.
Typical value: 5-10 seconds.
