ATEN VK2100, User Manual

Page: 28 / 127

ATEN Control System User Manual
18
IR / Serial
These four ports can be configured to connect IR and RS-232 devices. By
default the ports are set to transmit IR signals. Use the ATEN Configurator
software to configure the ports for RS-232 signals.
IR Connection: Connect a transmitter cable to the IR and Ground ports on the
VK2100 and install the IR transmitter on or near the device's IR receiving port,
as shown on page 19.
Serial Connection: Connect the device's receiver (RX) and ground ports to the
Serial (TX) and Ground ports on the VK2100. Next configure the same serial
port setting on the VK2100 and serial device so that they can communicate.
Uni-directional (+ -5 V)
Baud Rate: 300 to 115200
(default: 9600)
Data Bit: 8 (default) or 7
Stop Bit: 1 (default) or 2
Parity: None (default), Even or
Odd
IR:
Blu-ray / DVD Player, TV,
Audio Receiver, Projector, etc.
RS-232:
Camera, Projector,
Switch, Audio Mixer, Multimedia
Device, etc.
Connects to
4 x RS-232 Ports
TTL Level (0 to 5 V)
Carrier Frequency:
10kHz~455kHz
4 x IR Ports
or