APRILIA RX 125, Service Station Manual

Page: 32 / 219

•
Tighten (unscrew) the nut (3), locking
the set screw (1).
•
Check the empty travel at the clutch
lever end.
•
Refit he protection casing (2).
•
If the set screw (1) is fully screwed, fully
unscrewed or it is not possible to obtain
the correct empty travel:
•
Remove the protection casing (2).
•
Screw the nut (3) fully on the set screw
(1).
•
Screw the set screw (1) completely.
•
With a plain slot screwdriver (or a coin)
unscrew and remove the cap (4).
•
Insert the special spanner (5) supplied
with the toolkit, and loosen the internal
nut (6).
•
Introduce a plain slot screwdriver into
the special spanner (5) and tighten the
set screw (7) completely.
•
Loosen the set screw (7) half a turn,
about 3 - 4 mm (0.12 - 0.16 in), of the
lever travel (8).
•
Tighten the set screw (7) with the
screwdriver, operate the special span-
ner (5) and tighten the internal nut (6).
•
Screw the cap (4) again.
•
Check the empty travel at the end of
the clutch control lever (10 - 15 mm,
0.39 - 0.59 in ).
•
Refit the left side fairing .
•
Start the engine.
•
Operate the clutch fully and engage the
first gear.
Make sure that the engine does not stop, that the
vehicle does not tend to move forward and that the
clutch does not "slip" when accelerating or riding.
WARNING
Maintenance
RX SX 125
MAIN - 32