APRILIA RX 125, Service Station Manual

Page: 31 / 219

•
Top-up the reservoir you are working with (1 or 2) until the level goes over the minimum
marked MIN.
CAUTION
TOP-UP TO MAXIMUM LEVEL MARK ONLY WHEN BRAKE PADS ARE NEW. BRAKE FLUID LEV-
EL DECREASES GRADUALLY AS BRAKE PADS WEAR OUT.
WHEN TOPPING-UP, DO NOT EXCEED THE MAXIMUM LEVEL MARK WHEN BRAKE PADS ARE
WORN AS YOU RISK SPILLING FLUID WHEN CHANGING THE BRAKE PADS.
•
Check braking efficiency.
•
In case of excessive travel of the brake lever or poor performance of the braking system,
purge the air in the system.
Clutch system
Adjusting the lever
Adjustment clutch when the engine stops or the
vehicle tends to move forward even when clutch
lever is operated and the gear engaged, or if the
clutch "slides", resulting in acceleration delay con-
sidering the engine revs.
Minor adjustments can be carried out through the
set screw (1) ):
•
Remove the protection casing (2).
•
Loosen the nut (3) (screw in).
•
Turn the set screw (1) until the empty
travel at the clutch lever end is approx-
imately 10 - 15 mm (0.39 - 0.59 in) (see
figure).
RX SX 125
Maintenance
MAIN - 31