Anrtisu Cell Master MT8212B, User Manual, Page: 90 / 294

CW Signal Generator Mode (Option 28)
To select CW Signal Generator mode, press the MODE key and use the down arrow to
highlight
CW Signal Generator
and press ENTER .
The CW Signal Generator option provides a CW signal from the instrument. The primary
purpose of this signal is for sensitivity testing of receivers. To use this feature, the signal is
connected directly to the receiver being measured and the output amplitude is reduced until
the receiver drops the signal.
The external splitter feeds the signal into the instrument's RF input. The display shows the
output power and frequency. The amplitude is set using an external step attenuator. The ex-
ternal splitter and attenuator are customer-supplied.
Soft Keys
The following soft keys are available when entering CW Signal Generator mode, or by
pressing the FREQ/DIST function key while in CW Signal Generator mode:
q
Freq
— Enter a CW frequency from 25 MHz to 3000 MHz using the
Up/Down arrow key, or the keypad and the appropriate soft key for Hz, kHz,
MHz or GHz. Press ENTER to accept the input.
2-66
Chapter 2 Functions and Operations
MODE = CW:
SOFTKEYS:
Freq
Page
Up
Page
Up
Display
Setup
Help
Signal
Standard
Select
Standard
Page
Down
Page
Down
Select
Channel
Offset
dB
Top
of
List
Top
of
List
Back
Uplink
Downlink
Bottom
of
List
Bottom
of
List
Show
All
Show
Selected
Select/
Deselect
FREQ/DIST AMPLITUDE MEAS/DISP
Power
Monitor
External
Edit
Measure
Offset
Back
Ref
Level
Offset
Figure . CW Signal Generator Mode Softkey Menu Map