Anrtisu Cell Master MT8212B, User Manual, Page: 217 / 294

Transmission Measurement Procedure
Step 1. Connect the duplexer between the Cell Master
RF In
and
RF Out
ports.
Step 2. Connect a load to the other end.
Step 3. Set the start and stop frequencies to cover the frequency range of the duplexer.
Step 4. Disconnect the duplexer and connect a cable to the Cell Master
RF In
and
RF
Out
ports.
Step 5. Calibrate the Cell Master for transmission measurements as described in the pre-
vious section.
Step 6. Connect the duplexer and make the measurements.
Chapter 11 Transmission Measurement
11-3
DUPLEXER
HOLD
RUN
START
CAL
AUTO
SCALE
SAVE
SETUP
RECALL
SETUP
LIMIT MARKER
SAVE
DISPLAY
RECALL
DISPLAY
PRINT
MODE FREQ/DIST AMPLITUDE MEAS/DISP
SYS
ENTER
CLEAR
ESCAPE
ON
OFF
/
1 2
4
5 6
7 8
9 0
3
+-
.
S332D
Figure 11-3. Transmission Measurement Connections
Figure 11-4. Transmission Measurement