FREQ/DIST
Displays the frequency and distance menu depending on the measurement mode.
Frequency
Menu
The frequency and distance menu for cable and antenna analyzer measurements
provides for setting sweep frequency end points when
Freq
mode is selected. Se-
lected frequency values may be changed using the keypad or Up/Down arrow
key.
q
F1
— Opens the F1 parameter for data entry. This is the start value for the
frequency sweep. Press
ENTER
when data entry is complete.
q
F2
— Opens the F2 parameter for data entry. This is the stop value for the
frequency sweep. Press
ENTER
when data entry is complete.
q
Signal Standard
— Allows selection of the signal standard to be used.
q
Select Standard
— Opens the signal standard menu, showing the selected
signal standards. Press the
Show All
soft key to show the complete signal
standard list. The currently selected signal standards are marked with an
asterisk. Press the
Show Selected
soft key to show only the selected signal
standards.
q
Uplink
— Selects only uplink frequencies.
q
Downlink
— Selects only downlink frequencies.
q
Up+Down Link
— Selects uplink and downlink frequencies.
q
Back
— Returns to the previous menu.
Distance
Menu
Provides for setting Distance to Fault parameters when a DTF mode is selected.
Choosing
DIST
causes the soft keys, below, to be displayed and the correspond-
ing values to be shown in the message area. Selected distance values may be
changed using the keypad or Up/Down arrow key.
q
D1
— Opens the start distance (D1) parameter for data entry. This is the start
value for the distance range (D1 default = 0). Press
ENTER
when data entry
is complete.
q
D2
— Opens the end distance (D2) parameter for data entry. This is the end
value for the distance range. Press
ENTER
when data entry is complete.
q
DTF Aid
— Provides interactive help to optimize DTF set up parameters. Use
the Up/Down arrow key to select a parameter to edit. Press
ENTER
when
data entry is complete.
q
More
— Selects the Distance Sub-Menu, detailed below.
q
Loss
— Opens the Cable Loss parameter for data entry. Enter the loss per
meter (or foot) for the type of transmission line being tested. Press
ENTER
when data entry is complete. (Range is 0.5 to 5.0 dB/m, 1.524
dB/ft)
q
Prop Vel
(relative propagation velocity) — Opens the Propagation Veloc-
ity parameter for data entry. Enter the propagation velocity for the type of
transmission line being tested. Press
ENTER
when data entry is complete.
(Range is 0.010 to 1.000)
q
Cable
— Opens a list of cable three common coaxial folders (1000 MHz,
2000 MHz, and 2500 MHz) and one custom folder. Select either folder and
use the Up/Down arrow key and
ENTER
to make a selection. This feature
provides a rapid means of setting both cable loss and propagation velocity.
(Refer to Appendix A for a listing of common coaxial cables showing val-
2-10
Chapter 2 Functions and Operations
Summary of Contents for Cell Master MT8212B
