Anritsu Mainframe MU909060A Series, Operation Manual, Page: 81 / 190

2.7 Save and Load
2-27
2
General Operation
2.7.2 Load Setup
Setups can be loaded from internal memory or from a USB flash drive.
A setup file is supported only by its relevant application, i.e., a setup file
created by the Reflector application can only be loaded by the Reflector
application.
To load the setup file:
1. Press the Menu/Power key. The General Functions pop-up menu is
displayed.
2. Highlight Load and press the Set key. The Mass Storage Load
screen is displayed.
3. Use the Left and Right arrow keys to select the Device
4. Use the Up and Down arrow keys and Set key to select the Folder
and file.
5. When the required file is highlighted, press LOAD SETUP (F1) to
load it.
Figure 2.7.2-1 Mass Storage Load Screen
There is a file named “factory_default.cfg” in internal memory. It
contains the factory defaults. The factory default file only resets the
current application to the factory defaults; it does not reset any other
applications.
Note
A setup file can only be loaded by the same application as was used
to save it. For example, a Reflector setup file can only be loaded by
the Reflector application.
Note
Loading a setup requires the Network Master to have the same SW
options installed as when the setup was first saved. If any options
are missing, a pop-up window is displayed, showing the missing
SW options.