Anritsu Mainframe MU909060A Series, Operation Manual, Page: 4 / 190

For Safety
iv
WARNING
3. Laser radiation warning
•
NEVER look directly into the cable connector on the equipment
nor into the end of a cable connected to the equipment. There is a
risk of injury if laser radiation enters the eye.
• The Laser Safety label is attached to the equipment for safety use
as indicated in "Laser Safety" later in this section.
4. This equipment cannot be repaired by the operator. DO NOT attempt
to remove the equipment covers or unit covers or to disassemble
internal components. Only qualified service personnel with knowledge
of electrical fire and shock hazards should service this equipment.
There are high-voltage parts in this equipment presenting a risk of
severe injury or fatal electric shock to untrained personnel. In addition,
there is a risk of damage to precision components.
5. The performance-guarantee seal verifies the integrity of the equipment.
To ensure the continued integrity of the equipment, only Anritsu
service personnel, or service personnel of an Anritsu sales
representative, should break this seal to repair or calibrate the
equipment. If the performance-guarantee seal is broken by you or a
third party, the performance of the equipment cannot be guaranteed.
Be careful not to break the seal by opening the equipment or unit
covers.
6. This equipment should always be positioned in the correct manner. If
the cabinet is turned on its side, etc., it will be unstable and may be
damaged if it falls over as a result of receiving a slight mechanical
shock.
Always set up the equipment in a position where the power switch
can be reached without difficulty.
Repair
Calibration
Falling Over