Anritsu Mainframe MU909060A Series, Operation Manual, Page: 125 / 190

3.6 Ping Test
3-37
3
Ether
n
et Applicat
ion
The LED icon shows the lookup progress/result:
Black indicates lookup not execute.
Gray (Blinking) indicates lookup in progress
Green indicates lookup succeeded
Red indicates lookup failed
Test Config pane
Figure 3.6.1-2 Ping Test Setup Screen, Test Config. Pane
Item Description
Port Selection The test can run on either Port A or Port B.
Test Duration – Mode
The test can run in three different modes.
Continuous when requiring
continuous Ping test
Seconds when time-limiting test in
seconds
Frames when limiting length by
number of ping requests
Test Duration – Value Frames or seconds
Interval
Number of seconds between ping requests
Frames are transmitted back-to-back at 0.
Frame size Frame size in bytes
Timeout
Timeout in ms
Note
If the actual timeout period is longer than Interval, the Interval
setting is overruled.
Note
When Continuous mode is set, the test runs until the user presses
the Start key, which will stop the whole test schedule. All tests in
the test schedule after this test are therefore never executed.