Anritsu Mainframe MU909060A Series, Operation Manual, Page: 72 / 190

Chapter 2 General Operation
2-18
2.5.1 Basic
The Basic tab is the first tab (Figure 2.5.1-1) that is displayed when
starting an application (either Ethernet, Reflector or Pass Through). This
tab gives an overview of what connectors the hardware has and
information about link speed, mode and time.
Figure 2.5.1-1 Status (Basic)
[1] The picture shows the type of physical connector used by the
Network Master; the above shows two RJ-45 connectors. The two
states of the SFP connector are shown below.
SFP slot with module
SFP slot without module
[2] This shows the link speed and half (HDX) or full (FDX) duplex link
mode.
[3] This shows the current utilization as a percentage.
[4] This shows the percentages of incoming frames with errors.
[5] This shows the pin/pair crossing and what standard the current link
is using.
[6] This shows the elapsed link time for the two ports.
[7] This shows the total transmitted frames.
[8] This shows the total received frames.
Note
Timers/counters used in items 6, 7, and 8 above are reset when the
link is lost.
1
2
3
4
5
6
7
8