![background image](http://html1.mh-extra.com/html/amx/modero-nxd-1200v/modero-nxd-1200v_operation-reference-manual_2938937035.webp)
Touch Panel Accessories
23
NXD/T-1200V Wall/Flush Mount Touch Panel
Checking the NXT-BP battery charge
1.
Press the Battery Life Indicator button (FIG. 27) once to illuminate the Battery Life LEDs and display the percent
charge remaining on the battery (this indication lasts a few seconds).
2.
Repeat the above step for each NXT-BP battery.
3.
Charge the NXT-BP battery by either inserting it into the battery base or from within the optional NXT-CHG
charger (which can sequentially charge up to two batteries).
Installing the NXA-BASE/B to an NXT Modero Panel
The battery base must be installed onto the NXT panel without any NXT-BP batteries.
1.
Power Off the panel before attempting to use the NXA-BASE/B.
2.
Place the empty battery base onto a flat/level surface.
3.
Verify the alignment of the Panel Interface connectors between the panel (male connector) and base (female
connector) (FIG. 28).
4.
Carefully place the Modero panel over the base alignment pegs (FIG. 28 and FIG. 29).
5.
Gently apply downward pressure until the panel is securely mounted to the battery base (FIG. 29).
FIG. 27
NXT-BP (showing Battery Life Indicator button and charge)
Battery Life Indicator button
Battery Life (Charge) Display
If the 25% LED is blinking, this indicates there is less than 5% of a charge remaining
on the battery.
FIG. 28
NXA-BASE/B showing Panel Interface and connector locations
Panel Interface
Battery Compartment
pulls outwards
connector (female)
Alignment
pegs
Captive fasteners
(secure base to
panel)
The battery base cannot be "hot-swapped". A panel receiving power through a
connected 12 VDC-compliant power supply cannot have a battery base installed onto
the bottom of the panel while powered. POWER OFF the panel before installing the
NXA-BASE/B.
"Hot swapping" could damage the base and cause it not to be recognized by the
panel.
Summary of Contents for Modero NXD-1200V
