AMX Modero NXD-1200V, Operation/Reference Manual

Page: 42 / 176

Installation Procedures: NXD-1200V Panels
30 NXD/T-1200V Wall/Flush Mount Touch Panel
6.
Remove the four pan-head Housing Screws from the rear of the NXD unit (FIG. 33). These screws secure the back
box to the internal panel casing.
7.
Lift the back box housing to separate it from the internal panel casing.
Installing the MP-TP12 Back Box
1.
Unscrew the four pan-head Housing screws (#8-32) from the MP-TP12 rear plastic cover.
2.
Gently place the MP-TP12 back box over the internal panel casing (with the cable routing hole on the right-side of
the panel).
3.
Re-install and secure the four pan-head Housing Screws into their pre-drilled holes along the edges of the MB-TP12
back box (FIG. 34) and secure them using a grounded Phillips-head screwdriver.
4.
Place the I/O connector plate back over the connector opening and align the connector locations.
5.
Re-secure the I/O connector plate (using a grounded Phillips-head screwdriver) and re-secure the Stereo Output nut
on the Stereo Output jack.
FIG. 33 Location of the attachment screws on the NXD back box
Unscrew these four Housing Screws
DO NOT
these
DO NOT REMOVE
REMOVE
panel
securing
screws
these panel
securing screws
to remove the back box. These make direct
contact with the black outer housing.
DO NOT REMOVE THE FOUR PANEL SECURING SCREWS. These screws secure
the LCD to the metallic casing underneath.