AMX Modero NXD-1200V, Operation/Reference Manual

Page: 36 / 176

Touch Panel Accessories
24 NXD/T-1200V Wall/Flush Mount Touch Panel
6.
Firmly grip both the panel (from the side) and battery base (from below) together.
7.
Gently place the touch panel LCD facedown onto a soft cloth (this prevents scratching of the LCD while the battery
base is being secured
).
8.
Locate the captive fasteners on the underside of the battery base by angling the base combo slightly forwards.
9.
Secure each captive fastener head using a grounded flat-head screwdriver until the NXA-BASE/B is securely
attached to the underside of the NXT Modero touch panel.
10.
Firmly grip the panel LCD/base combo and gently rotate the unit back onto the base.
Installing an NXT-BP into the NXA-BASE/B
The battery base does not directly connect to a power supply, but rather receives its power directly from the Modero
panel, through the Panel Interface connector.
1.
With the panel mounted on the battery base, open the battery compartment (FIG. 30) by pulling the handle
outwards. This compartment houses two NXT-BP batteries.
FIG. 29 NXA-BASE/B shown aligning with NXT panel
Panel Interface
connector
Alignment
pegs
Interface
connector
Captive
fasteners
(male)
Top view
Bottom view
(female)
Remove any connectors from the rear of the Modero NXT panel before continuing
with the installation of the batteries. Power can only be supplied after the batteries
have been installed.